Fire Safety & Candles

There’s a special beauty and tranquillity to candles, but a lighted candle is also an open flame, and a potential fire hazard if not carefully monitored. An estimated 8,200 home fires are started by candles each year according to the National Fire Protection Association.

A study by the U.S. Consumer Product Safety Commission suggests that 85 percent of candle fires could be avoided if consumers followed three basic safety rules:

• Never leave a burning candle unattended.
• Never burn a candle on or near anything that might catch fire.
• Keep candles out of the reach of children and pets.

How to Burn a Candle Safely

Before Lighting:

• Before burning, always trim the wick to ¼ inch. You can use a wick trimmer, nail clippers, or scissors. Long or crooked wicks can cause uneven burning, dripping, or flaring.
• Keep the wax pool clear of wick trimmings, matches, and debris always.
• Always use a candleholder specifically designed for candle use. It should be heat resistant, sturdy, and large enough to contain any drips or melted wax.

 Burn candles in a well-ventilated room:

•  Avoid drafts, vents, or air currents. This will help prevent rapid or uneven burning, soot, and excessive dripping.
• Follow the manufacturer’s recommendations on burn time and proper use. In general, it is recommended that candles do not burn for longer than four hours and cool for at least two hours before relighting.
• When lighting a candle, use long matches or a long-reach lighter. Keep your hair and loose clothing away from the flame.

While Burning:

• Never leave a candle unattended.
• Never burn a candle on or near anything that can catch fire. Keep burning candles away from furniture, drapes, bedding, carpets, books, paper, flammable decorations, etc.
• Keep candles out of the reach of children and pets. Do not place lighted candles where they can be knocked over by children, pets, or anyone else.
• Never touch or move a candle while it is burning or while the wax is liquefied.
• Don’t burn a candle all the way down. For a margin of safety, discontinue burning a candle when 1/2 inch remains in the container or 2 inches if using a pillar candle.
• Place burning candles at least three inches apart from one another. This is to make sure they don’t melt one another or create drafts that will cause the candles to burn improperly.
• Extinguish a candle if the flame becomes too high or flickers repeatedly. Let the candle cool, trim the wick, and check for unwanted drafts before re-lighting.
• Never use a candle as a night light or while you may fall asleep.
• Be very careful if using candles during a power outage. Flashlights and other battery-powered lights are safer sources of light during a power failure. Never use a candle during a power outage to look for things in a closet, or when fuelling equipment – such as a lantern or kerosene heater.

When Extinguishing a Candle: 

• Use a candle snuffer to extinguish a candle. It’s the safest way to prevent hot wax from splattering.
• Never use water to extinguish a candle. Water can cause the hot wax to splatter and might break a glass container.
• Make sure the candle is completely out and the wick ember is no longer glowing before leaving the room.
• Don’t touch or move the candle until it has completely cooled.
• Never use a knife or sharp object to remove wax drippings from a glass holder. It might scratch, weaken, or cause the glass to break upon subsequent use.

References:

• National Candle Association, USA https://candles.org
• The National Fire Protection Association (NPFA), USA https://www.nfpa.org